f2c's dashboard

T-bone replied on June 25, 2008 07:57 to the question "how to command the RS232 lines on EM1202EV-RS-01 board" in Tibbo:

Hello, the IO mapping are as follows:

CTS > GPIO 10
RTS > GPIO 11
DSR > GPIO 12
DTR > GPIO 13

f2c asked a question in Tibbo on June 21, 2008 22:10:

how to command the RS232 lines on EM1202EV-RS-01 board

Hello everyone,
I have a EM1202EV-RS-01 board, and, I need to connect to a device that needs the DTR on. I suppose that to set the DTR I need to use the io.state.
The problem is to know which is the line to enable (from the manual - platform dependet- All I/O lines of the EM1202 platform require explicit configuration as inputs or outputs ). which line PL_IO_NUM_x I have to enable on this board to bset the DTR signal? (there isn't the manual for this board)
thanks for the support

ciao
Fabio

A comment on the discussion "Welcome to the new Tibbo forum!" in Tibbo:

Hi f2c!

Can you maybe start a new thread ("post a message") with your question, so that we can follow it more easily? – ezuk, on June 15, 2008 07:17

f2c replied on June 14, 2008 00:22 to the discussion "Welcome to the new Tibbo forum!" in Tibbo:

Hi Ezuk, I'm back after "some" time (due to busy period) on my experiments.
So, I have a EM1202EV-RS-01 board, and, I need to connect to a device that needs the DTR on. I suppose that to set the DTR I need to use the io.state.
The problem is to know which is the line to enable (from the manual - platform dependet- All I/O lines of the EM1202 platform require explicit configuration as inputs or outputs ). which line PL_IO_NUM_x I have to enable on this board to bset the DTR signal? (there isn't the manual for this board)
thanks for the support
Fabio

A comment on the discussion "Welcome to the new Tibbo forum!" in Tibbo:

Should be possible. Maybe you can open a new thread and ask this, and then more people will see your question? – ezuk, on April 13, 2008 08:33

jochez replied on April 11, 2008 09:21 to the discussion "Welcome to the new Tibbo forum!" in Tibbo:

Have anyone tried to implement an printer driver in the device?
Is it possible?!

ezuk replied on April 07, 2008 08:55 to the discussion "Welcome to the new Tibbo forum!" in Tibbo:

Heya!

Yup, setting the RTS and DTR level should be possible in Tibbo BASIC.

Re the manual -- lots of the docs you need already exist. If you have specific questions, please ask here.

Re the FD object -- we know that's not documented yet. We are working on it, but I can't promise any specific deadline...

f2c replied on April 06, 2008 21:03 to the discussion "Welcome to the new Tibbo forum!" in Tibbo:

Hello, I have buy an EM1202EV-RS-01 board, to make some experiments with your product. I would know when you will release the manual, and if on this board I can set the level of the RTS and DTR lines. Thanks, Fabio