Jim's dashboard

Jim replied on July 18, 2009 03:21 to the problem "Live Feed Cut Off" in Qik:

When I am connected through opera or skyfire I have no problems. Same with you tube. Checked connection and it's 3G. as soon as I stop recording it uploads to website. Delay shows greater than one minute. also with 4.03 I can't bring up settings menu.
It would be great if you had a software users manual or info on what each icon meant.

Jim reported a problem in Qik on July 17, 2009 00:31:

Live Feed Cut Off

i910 starts with live feed for a few seconds then it shows a delay timer that never stops going up. The videos uploaded to the site are the segments I was streaming before it starts the delay. Basically stops live feed.

Jim reported a problem in Qik on June 29, 2009 13:36:

New Alpha version on omnia 910 freezing

New Alph version crashing on omnia 910. It loads up you can register even set up then camera comes on for 5 secs and it freezes up my phone. need to reset to get phone working again. I am using Cracked cc20 Rom.

Jim replied on June 29, 2009 13:29 to the question "NEW beta TEST rom from Samsung for Omnia I-910 and qik 2_25 wont completely load" in Qik:

Mr. Syvrachev,
everything works fine until the camera comes on then it works for about 5 secs and I get the white screen again and it freezez my phone so I have to do a soft reset.

Jim replied on June 09, 2009 17:34 to the question "NEW beta TEST rom from Samsung for Omnia I-910 and qik 2_25 wont completely load" in Qik:

reflashed phone with adrynalyn's 6.5/ 3.6.1 build# 21806 and it still does the same thing

Jim replied on June 08, 2009 14:22 to the question "NEW beta TEST rom from Samsung for Omnia I-910 and qik 2_25 wont completely load" in Qik:

Thats great if you have the 6.5 Rom but what if you still have the original leaked rom with 6.1. I'm getting the same problem. and I don't want to flash my phone again. I have to much on it to reload.

Jim replied on June 08, 2009 14:13 to the problem "Samsung Omnia Stuck Sideways" in Qik:

you have to go into settings> System> Motion Sensor and chande the setting back to automatic. It does this every time you run QIK