Loading Profile...
EDT,T20, T30 in two measurements?
Chris-
I am using Fuzzmeasure to get EDT,T20, & T30 measurements for fairly large spaces and am encountering a situation where the Dodecahedron that i built can't put out enough SPL to get a good SNR below about 150Hz. I was wondering if it is acceptable mathemetically to do the impulse measurement in two pieces; Low using a good low freq speaker (20-150Hz where directionality of the sound is not as big an issue) and High (150-20KHz) using the dodec. I would actually set the sweep measurement to these values and use the reverb results from the two measurements.
Thanks for a tremendous product!
Matt Schuster
I am using Fuzzmeasure to get EDT,T20, & T30 measurements for fairly large spaces and am encountering a situation where the Dodecahedron that i built can't put out enough SPL to get a good SNR below about 150Hz. I was wondering if it is acceptable mathemetically to do the impulse measurement in two pieces; Low using a good low freq speaker (20-150Hz where directionality of the sound is not as big an issue) and High (150-20KHz) using the dodec. I would actually set the sweep measurement to these values and use the reverb results from the two measurements.
Thanks for a tremendous product!
Matt Schuster
I’m really impressed with FM
3
people have this question
I have this question, too!
Tell me when someone answers.
The more people who ask this question, the more it gets noticed.
The more people who ask this question, the more it gets noticed.
Create a customer community for your own organization
Plans starting at $19/month
