Help get this topic noticed by sharing it on Twitter, Facebook, or email.

Eurotherm 2408 setpoint issue

Dear
Eurotherm 2408 installed with our growth system the module is connected through cane networking to control the temp. of the system. Now we are running the 2408 module in auto mode. We set the cell temp. 150C in our growth recipe. During the recipe running the temp. of the cell increases with time and the eurotherm module may not shut off the heater after achieving the required set temp.
The system is continuously displaying 294 in the upper part of the module and 4dEu is blinking two time and 10 is blinking one time. this repeating blinking is showing continuously.
But the system shut off the heater in that step of the recipe where we set to OFF the heater.

Please help us in this regard to control the system temp.
1 person has
this problem
+1
Reply