Eurotherm 2416 Controller Status does not change

Hello,

The Eurotherm controller on one of my furnaces will only increase the temperature if the set point is changed.

If use the segments (segment 1, tGt =100, ramp rate = 10; (segment 2, tGt =100, dwell = 1 hr etc.) in the program list, the Status (in the Run List) does not change from OFF to Run.

I have tried checking to ensure that the Run/Hold button is enabled in the configuration and that the Stat parameter is alterable from the edit configuration.

Any help would be appreciated because this problem is causing delays.

Thanks in advance!

Nate
2 people have
this problem
+1
Reply