Help get this topic noticed by sharing it on Twitter, Facebook, or email.

Mini8 - Configure over ethernet

Hi,

I have been trying to "get online" to a Mini8 Eurotherm controller via ethernet without much success.

Firstly, is this even possible? I have read through the manual and it wasn't clear (or at least not to me).

If it is possible would someone assist me with setting this up?

This is what I have tried so far:

Configured iTools through Windows control panel



Setup my laptop with an IP address within the same range:



Initiated a scan from within iTools Engineering Studio:



I had my laptop connected point-to-point with the FC port on the Mini8 controller.

Any help would be greatly appreciated or if further information is required I would be happy to provide it.

Thank you
Scott
1 person has
this question
+1
Reply