Help get this topic noticed by sharing it on Twitter, Facebook, or email.

Overshooting the Set point

Hi,
I am trying to use SP1 and SP2 options to increase the temperature from 25 to 65, at an SPrr of 1 degreeC/min, followed by dwell of 10 minutes.
I am using the same values of PID parameters for all the three controllers on my eurotherm 2216e controller.
However, the temperature in the upper and lower controller overshoots to 96C and doesn't reduces to the required temperature of 65C, but the temperature in the middle controller increases at the desired pace and dwells at 65C for 10 minutes.
THe parameters I am using are Pb =2, ti=5, and td=10.
Can you please help.
1 person has
this problem
+1
Reply