Hello,
Use oven controller that has a timer connected to outputs 3A and 3B.
When the set alarm timer is not included. The problem is when new controller, the timer is tested with another controller available. Which setting can be a problem.
Help get this topic noticed by sharing it on
Twitter,
Facebook, or email.


-
Hello Gabriel,
Please can you send me more details about your setup as I do not quite understand your question.
Where are you located, perhaps contacting our local office may be better for you? -
-
Hello Bob,
You have to make adjustments to the controller sends a signal to the relay output when it reaches the set alarm. Which settings to send
I am in Bulgaria -
-
Hello Gabriel,
Please correct me if I am wrong, but I believe you are trying to set a Relay to active on an alarm.
If this is correct, what type of alarm do you require and which output are you using?
If you wish to speak to someone about this:-
Your local contact is our Italian office details below.
info.eurotherm.it@schneider-electric.com
Tel: (+39 031) 975111 -
-
-
-
Hello Gabriel,
To setup this alarm enter config level.
Page to ACCS,
Press the Scroll key for codE 0.
Select 1.
Press the Scroll key for Goto.
Select conF.
Press the Scroll key ConF 0.
Select 2.
Observe ConF Pass.
Page to AL.
Scroll to a vacant alarm, such as AL1.
Select dEu.
Page to 3A.
Scroll to Func.
Select diG.
Scroll to diGF.
Press the up arrow key to find 1dEu and release the button.
The message will show noch.
Scroll to SEnS.
Select nor (short circuit on alarm) or inu (open circuit on alarm).
Press the Page and Scroll keys together,
Observe Exit and select Yes.
Enter Full level.
Page to ACCS,
Press the Scroll key for codE 0.
Select 1.
Press the Scroll key for Goto.
Select Full.
Page to AL.
Scroll to 1dEu.
Using the arrow keys enter you alarm value.
This will now be setup for deviation band alarm. -
-
Hello Bob,
With this setup controller work correctly.
Thank you very much for your help.
Have a nice day! -