Help get this topic noticed by sharing it on Twitter, Facebook, or email.

Set a setpoint in Eurotherm 2704 via modbus

Hi,

We're developing a project in LabVIEW where we're using a Eurotherm 2704. We couldn't find the LabVIEW drivers for this model but we took a look at the drivers for the 3500 series.

We noticed that the modbus addresses are different between these models so we're trying to use the VIs that we need from the 3500 series drivers for the 2704 we're working after changing to the appropriate modbus addresses.

Looking at the 2704 manual we couldn't find any modbus addresses to set a setpoint, but for the 3500 series there's addresses to do this. Is it possible to set a setpoint in the 2704 model through a modbus address?

Thanks
1 person has
this question
+1
Reply