Help get this topic noticed by sharing it on Twitter, Facebook, or email.

iTach Led Lighting Commands in iRule

I'm using a GC iTach as LED Lighting to control my under cabinet leds. I finally got the right device to amplify the PWM signal from the iTach so that I can send commands to toggle power and dim the led's.

I'm sending set_LED_LIGHTING,1:3,50,1 to the iTach from iTest and everything works as it should, but I don't know what I need to do to convert this command so it will work in iRule.
I have imported other user's devices that were led setups and played around with the contents of the device codes for a couple hours and didn't have any luck.

1:3 (iTach module number)
50 (led intensity)
1 (linear ramp rate)

Thanks
1 person has
this question
+1
Reply