Help get this topic noticed by sharing it on
Twitter,
Facebook, or email.
Twitter,
Facebook, or email.
Garage Door Remotes no longer work after myQ installation
Has anyone experienced this recently? I installed the MyQ after a few issues (user based) and now my regular remotes no longer work. I will say that one of my issues as that I pushed the learn button but was pushing it until it blinked - I didn't read the instructions correctly. You are supposed to push and release the button - duh. I pushed it until it went out (of course, the gateway didn't work until I did the push and release correctly). Did pushing the learn button mess up the other controllers? Just asking.
-
Based on a quick search it sounds like you cleared the memory and likely it caused you remotes to not be linked. Should be able to simply re-add them by going through the learn process.
1. Clear the memory of the opener. Press and hold the learn button until the LED light turns off (approximately 6 seconds). How to find the learn button on my garage door opener
2. Reprogram the remote controls. How to program a remote control
3. Reprogram the keyless entry. How to add, program or change a Keyless Entry PIN -
Loading Profile...




