Help get this topic noticed by sharing it on
Twitter,
Facebook, or email.
Twitter,
Facebook, or email.
Garage door stops at various point when opening. I've installed several and should know what i'm doing but am now stumped. Any advice?
my garage door has a mind of its own now. I have installed 4 or 5 openers in my time, I know about the force limits and settings to raise it up more etc etc. Sometimes now it works and other times it just stops a various point. I have checked everything I know of any further advise
-
Close garage door, pull disconnect (disconnect trolley from door), manually move door fully-open and fully-closed several times. Any difficult sections of door motion? Check hinges and rollers for loose screws, alignment, etc.
-
-
I seem to have this problem also. The travel module will not travel all the way down. even when disconnected from the door. It goes about 1 rail length then stops and returns up. Even when holding the down button during the programming phase it will stop in the same location and refuses to move. Everything is aligned, door safety sensors are clear. Any thoughts??
-
Loading Profile...





