ProFire 610 firmware updater frozen at 1%.

ProFire 610 firmware update is frozen at 1%. I'm running through a dedicated FireWire card and using Win7 64bit SP1.

Initially I downloaded the latest drivers and installed, THEN hooked up the 610 and powered it on when I was instructed to. When I went into ProTools (that does not yet recognize the device) a Firmware Updater automatically started and for the next twenty minutes did not proceed past 1%. At the 0:20 mark I held my breath, powered the 610 down and rebooted.

I then uninstalled the 610 driver and reinstalled it. I'm getting the same results.

Is there a remedy to this? Thanks for your time!!
1 person has
this question
+1
Reply