Cursor jumps to center of screen when moving back from PC1 to PC2.

  • 1
  • Problem
  • Updated 2 months ago
  • (Edited)
My setup is PC1 (1 screen) and PC2 (3 screens).  When moving the mouse from PC2 to PC1, the cursor smoothly tracks from the edge of last PC2 screen to the correct, relative position at the corresponding edge of PC1's screen.  But when moving the cursor back to PC2, it leave the edge of PC1's screen and jumps to the center of the adjacent screen (on the x-axis) on PC2, although along the same y-axis plane as it was when it left PC1's screen.  All screens are at the same resolution (1920 x 1080).

This behavior did not occur initially after installing on PC1 (MwoB was already installed on PC2).  The same behavior occurred with a different PC1 as well (PC2 is my main PC, and I'm swapping out PC1 as I work to refurb various computers).

From some testing, if I remove the PC2 screen that is otherwise adjacent to PC1, I don't have the jumping-cursor problem (at least initially) when moving the cursor back from PC1 to PC2.

Any ideas?

This is a great utility, by the way.  Until I learned about it recently, I was dreaming of some elaborate setup that would track which PC's screen I was looking at, and let me have one kbd/mouse to control them both without having to use a KVM switch. :-)
Photo of VM

VM

  • 1 Post
  • 0 Reply Likes

Posted 2 months ago

  • 1

Be the first to post a reply!